![]() The new hose is then pulled in with the mule tape.Īlex is taping the new hose onto the mule tape to be pulled in. No more cords showing!Īlex and Andy feed the mule tape in the boom as the old hose is pulled out. There are similar valves on all the boom cylinders as well for safetyĪ view of the turret with the new hoses installed and connected. The valve on the top of the cylinder is a safety valve so if a hose breaks in the truck the cylinder wont drain and drop the truck. These were all pulled, inspected, bolts torqued and hoses replaced. Norman did find the homemade tractor in my shop and had to try it out. Justin feeds one of the new hoses through the elbow on the boomĪs I pulled one of the new pump hoses under the truck I had lots of encouragement from the side One of the new hoses getting pulled into the boom Thanks Alex Manz, Andrew Meyer, Andrew Nelson, Justin Malland, and Cris Anderson for the help!Įvery Good crew needs a good chief. To avoid getting hoses crosses one hose was pulled out pulling muke tape on and then new hose pulled in with the mule tape. All 4 outriggers were pulled and inspected also as we replaced hoses and one cylinder is going in for repair. Much of the hose on this truck was still original and showing off age. 13 more short ones will be made this week. Reel Pro-Pull Measuring Pull Tape Tensile Strength 1250 lbs. Bucket Pro-Pull Measuring Pull Tape Tensile Strength 400 lbs. Just under 600 ft, 31 hydraulic hose assemblies were replaced. Made from woven polyester fiber, Pro-Pull Measuring Pull Tape maintains softness for less hand damage than traditional polypropylene rope while minimizing. This past Saturday the shows bucket truck got some more work done at my shop. Thanks Justin Malland, Jerry Christiansen, Merle Myers, Duane Hovelsrud, Jake Hovelsrud Tom Hall, Mark Kerkvuet for coming out and working on the truck and Andrew Nelson for lining up many of the parts and help with the welding work to come patching up the boxes. This has been hooked up and fuctions now. The truck is also equipped with a 12v emergency pump that will operate the boom in case of engine failure. This truck is also getting some electronic engine controls including 2 speed idle for faster pump operation and remote start stop from the bucket. Backup camera installed as well as strobes and back up alarm. The truck also got a full fluid change, new brake pads, rotor and a caliper. The clutch and transmission are back in the truck and drive line rehung with sturdier brackets. Bucket Straps Shop Blankets Shop Latigo & Off Billet Sets Shop. The main reason the truck came home was to get a new clutch and transmission work and to diagnose some hydraulic gremlins. Tired of the same old, uninspiring horse halters Say hello to our Woven Nylon Mule Tape. Yesterday some Rollag friends came out for a work day to work on some reassembly and more maintenance items. ![]() I started working on the unit around Christmas and there have been several work evenings of Justin and I working on the truck also. WMSTR's bucket truck has been spending the winter in my shop for some needed TLC.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |